Camera won't connect

Glimpo tests every camera before saving it and tells you what actually went wrong, instead of “connection failed”. Find the message you saw.

My camera isn’t in the scan, or says “RTSP is off”

Glimpo finds cameras even before streaming is switched on, from the device’s maker and the network ports it keeps open. It never tries a password while scanning. A camera marked RTSP is off is on your Wi‑Fi but won’t share video with other apps yet:

• Tapo: in the Tapo app open the camera → Settings → Advanced Settings → Camera Account and make a username and password for Glimpo. That switches RTSP and ONVIF on.
• EzyKam+ (CP PLUS): camera → Settings → turn on Local access or ONVIF, and set a device password. If there’s no such switch, that model is cloud-only and can’t stream to other apps.

Then tap Check again. Some cameras take a minute after the switch.

Still not listed at all? The camera may be on a guest Wi‑Fi or another network from the hub, or asleep (battery cameras). Use Enter IP or RTSP link with the address from your router’s device list.

Adding an NVR or DVR

Pick the recorder’s brand and sign in with the recorder’s own login. Glimpo asks the recorder for its channels and lets you pick which become cameras; each counts toward your plan’s camera limit.

“The camera refused that username or password”

The camera answered, but the login was wrong.

• Use the camera’s own password, not your Wi‑Fi password or app login. See Which password does my camera want?
• Tapo: the username is the Camera Account you created, not admin and not your TP‑Link ID.
• Glimpo shows how many tries are left before the camera locks itself. Stop and check before the last one.

“Too many wrong passwords, so the camera locked itself”

Many Dahua-based cameras (Imou, CP PLUS, Dahua, Amcrest) lock for 30 minutes after 5 wrong tries. Nothing is broken. Glimpo shows when it unlocks; wait, then use the right password.

“The camera is on, but streaming to other apps is switched off”

The camera refused the connection. Switch local streaming on in its app:

• Imou Life: camera → Settings → More → RTSP / ONVIF (or “Local access”).
• Reolink: Settings → Network → Advanced → Port settings → RTSP.
• Tapo: create a Camera Account; that switches streaming on.
• EZVIZ: turn off Image encryption, and turn on local streaming if your model shows it.
• EzyKam+ (CP PLUS): enable Local access / ONVIF if available.

“The password may be right, but the camera won’t share its video”

Same cause as above: streaming to other apps is off, or the model only streams to its own cloud. Some cloud-only EzyKam and EZVIZ models don’t offer local streaming at all.

“Nothing answered at that address”

• The camera’s IP address may have changed. Run the scan again, or check your router’s list of devices. Giving the camera a fixed (reserved) address in your router prevents this.
• The camera may be on a different network from the hub, such as a guest Wi‑Fi or a separate VLAN. Put them on the same network, or allow traffic between them.
• Battery cameras sleep. Reolink battery cameras need a Reolink Home Hub to stream continuously.

“The camera answered, but not on the usual stream link for this brand”

Your model uses a different stream path. Choose Any ONVIF camera so the camera tells Glimpo its links, or paste the exact link under RTSP / other URL.

The camera worked, then went offline

Check the camera’s health in the app (status, codec, bitrate). Wi‑Fi cameras far from the router drop out most; a wired camera or a closer access point fixes it. If the hub itself is offline, see Hub offline or storage problems.

Still stuck?

Contact support with the camera brand and model, the app you set it up with, and the exact message Glimpo showed.